27 May 2012.

What happened just now reminds me of the joke about the computer user who had a problem. She called in a technician and he sorted it in a few seconds. She wanted to know what the problem has been? He replied:"It was an ID ten T error". She wrote it down to tell her friends: "ID10T" I nearly had my post finished, and accidentally touched a wrong key somewhere, and lost it all.

Now where were I?

Last week I said the window was nearly finished. We have removed the rotten frame and built a new frame, leaving the windowsill in place. Every night we put the sliding sashes back in to close the big hole. We had some broken or cracked panes of glass  in the sashes, which obviously needed replacing. If bought new, they cost $ 57.

When we first saw the house in 2009, there were windows lying on the deck. In 2006 they installed one in place of a rotten one in the western wall. When we bought the place, the other was still lying there, with pieces of the rotted one as well. We put them in storage. Beginning to work on the windows, we learnt that the original ones were 40 inches, as opposed to 34 for the replacement ones. We also learnt that two panes could possibly be salvaged from the sashes that was thrown out. Now, my rate of success in removing old glass from wooden frames is nearly zero. But I have seen an tool advertised on TV which cuts with a vibrating action, like they used to remove plaster casts in the old days. These tools cost up to $ 260, but I bought a cheap one at $ 60. I managed to remove two panes from the old sashes, and all the broken and cracked ones from our window. In lifting one glass out of the frame, it just shattered in my hands. Well, one was still in the sash, and we had three more.

We sanded the sashes down, and repainted them all. Sometimes the humidity was too high outside, and we had to put them in the house and put a heater on. I fitted the new/old glass. We also installed the new sash cords.

As we had to refit the sashes every night, I learned that my frame was too narrow at the top. Luckily it was screwed together. I quickly removed the screws and refitted it a bit wider. Now it turned out it was too wide, and the frame was too tall. We would have a nice draught over the top. Next day I measured again, and cut back where necessary and reassembled the frame. Nice fit now.

At last we could start with the final assembly. We first fitted the top or outside sash, and it worked just fine. Next was the bottom one. I put it in position, and asked Elna to look for the weights while I went outside to fetch something. I heard a big crash. A gust of wind had blown the sash out, breaking tie only pane of glass that was not replaced. We stuck a piece of perspex over it, and installed the weights. Next we sealed all the air gaps between the timber architraves. Much better now.

I have been buying aluminium windows on Trademe to salvage the glass and try and cut it down About 50% success rate. On Friday I won an auction for two windows at $ 15.50. We went to pick it up yesterday, and it turned out it was a group of people converting a house into a church. When I explained what I was doing, the guy said they had a lot of glass, I could help myself. I got  two more sheets of glass. I gave them $ 20, thus $5 each. The window is still not finished, but we are getting there, slowly.

Our two sheep were complaining about their grass. Totally unjustified, but they were bleating a lot. On Saturday afternoon we decided to put them each on a chain. It worked for about 30 minutes, they broke their collars, bad leather. Now they were running free in the yard. I have been planning to repair the street fence, since there is only three steel wires. Now it became a necessity. We put chicken fence against the wire, as a temporary measure. Tomorrow I will be doing some fencing again.We have a nice steel farm gate that should fit. We will not be moving over this week.

Never a dull moment

Bye
G&E